SATO GL4XXE Manual de Serviço descarregar pdf (Página 166)

Unit 7: Replacement Procedures

GL4xxe Series Service Manual

7-27

INTERNAL REWINDER RETRACTION BASE-PLATE REMOVAL

The ribbon-end sensor informs the operator when ribbon stock has been exhausted and reloading is required.

1. Remove the Internal Rewinder’s front cover if it is in place. See “INTERNAL REWINDER FRONT COVER

REMOVAL” on page 7-25

2. Remove four screws (1) as shown in Figure 7-22 to remove the retraction base plate (2).

Figure 7-22, Internal Rewinder Retraction Base Plate Removal

NOTE: Ensure all loose components are properly positioned before you tighten the

associated screws.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 203 204

Sem comentários

SATO GL4XXE Manual de Serviço Página 166