SATO M8485S Manual do Operador descarregar pdf (Página 51)

Section 3. Confi

uration

3. Calculate the starting point voltage using the formula.

4. Use the LINE key to step the counter to the desired setting.

The display will increment one step for each time the LINE

key is pressed. If the LINE key is held pressed for more

than two seconds, it will automatically

go into the fast scroll

mode. The reading will advance to a setting of 4.9 (the

maximum voltage) after which it will automatically wrap and

start at

“0.0”

again. If a value of

“0.0”

is set, the printer will

automatically set the level each time the printer is powered

on with labels loaded and the head is closed.

5. Once the setting iscorrect, pressing the FEED key will

accept the setting and advance the next display.

e 3-22 SATO

“Se”

Print En

ines

EYE [

.XXV]

INPUT

[

X.XV

]

EYE - When setting the

“eye”

threshold, the voltage must be

measured with nothing but the label under the sensor and

then again withthe printed

“eye”

mark under the sensor. The

formula for this is:

(High Voltage Level + Low Voltage Level) x 0.5 = Start Value

1. Insert a label into the sensor and close the Label

Hold-Down. Make sure the printed

“eye”

mark is not under

the sensor. Record the voltage shown on the top line of the

LCD panel. This line should have the message

“EYE”

on the

top line (DIP switch DSW2-2 = ON).

2. Now pull the label forward until the

“eye”

mark is positioned

under the sensor (the voltage reading should be at its

highest point). Record the voltage shown on the top line of

the LCD panel. The voltage ranges measured should be

within the following ranges:

Eye-Mark = 2.5V to 3.5V

Label Only = Less than 1.0V

If the measured

values are outside this range, you may

have trouble in finding a value that will work properly under

all conditions. If this is the case, a higher quality label may

be needed to get adequate performance.

3. Calculate the starting point voltage using the formula.

4. Use the LINE key to step the counter to the desired setting.

The display will increment one step for each time the LINE

key is pressed. If the LINE key is held pressed for more

than two seconds, it will automatically

go into the fast scroll

mode. The reading will advance to a setting of 4.9 (the

maximum voltage) after which it will automatically wrap and

start at

“0.0”

again. If a value of

“0.0”

is set, the printer will

automatically set the level each time the printer is powered

on with labels loaded or the head is closed.

5. Once the setting is correct, pressing the FEED key will

accept the setting and advance to the Online Feed display.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 106 107

Comentários a estes Manuais

Sem comentários

SATO M8485S Manual do Operador Página 51

Comentários a estes Manuais

Manuais e produtos relacionados com Impressoras de rótulos SATO M8485S