SATO M8485S Manual do Operador descarregar pdf (Página 22)

Section 2. Installation

SWITCHES AND SENSORS

Cover Open Switch The printer mechanism cover is fitted with a micro

switch. When the cover is opened, this switch is

activated and the printer will stop printing.

Ribbon Motion Sensor The sensor will react to the carbon ribbon unwind when

approximately 46 feet of ribbon remain. This sensor is

a motion detector

that signals the printer when the

ribbon supply is turning. This sensor is used for both

the ribbon end and ribbon near end sensing.

Note: The M-8459Se Direct Thermal print engine does

not use a Ribbon Motion Sensor.

Head Open Switch When the print head is opened, this switch is activated

and

the printer will stop printing.

Label Sensor This sensor unit contains two sensors for both label

gap and Eye-mark sensing.

SATO

“Se”

Print Engines Page 2-5

A note about LEFT HAND and RIGHT HAND models

The print engines are available in RIGHT HAND and LEFT HAND and models. In Right Hand

models, the label roll is loaded on the right-hand side of the printer, while the Left Hand

models, the label roll is loaded on the left-hand side. However, models sold in the USA are

named according to the direction of label feeding. Thus, Right Hand models feed the label

from the left to the right, and Left Hand models load labels from the right to the left.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 106 107

Sem comentários

SATO M8485S Manual do Operador Página 22